Ships Factory Direct In 3-4 Days
Be the first to review this product and earn a chance for a $10 store credit when you place a review on this product post purchase.
The Briggs & Stratton 16-kilowatt, standby generator package keeps your home and family safe and secure during during a power outage. With the included 150 amp automatic transfer switch and A/C control module, it supplies and manages power to all your home appliances and is suitable for most medium-sized homes.
Required clearances as close as 18 inches to the home and a front facing exhaust make it possible to place the generator where tight lot lines and other factors might otherwise limit installation. Fuel choices include LP gas (propane) and natural gas. The genset is UL2200 rated and meets CSA 22.2 requirements. It is EPA compliant and comes with a four year, 1600 hour limited consumer warranty.
Not for sale to California
The generator produces 16 kilowatts of power using LP gas. At full load, consumption runs about 3.14 gallons per hour, and about .71 gallons per hour at half load. When running on natural gas, the generator is capable of 14.4 kilowatts of power and uses 163 cubic feet at half load, and 244 cubic feet at full load.
The amount of fuel consumed is dependent upon the electrical load placed on the generator, and changes as the load changes. The fuel solenoid located at the back of the unit controls the flow of gas to the engine and may be shut off in an emergency.
The 16 kilowatt generator has a 35 horsepower, 993cc Vanguard V-Twin engine made by Briggs & Stratton to turn the generating unit. This engine was engineered by Briggs & Stratton to meet stringent standards for home generator systems. A pressurized oil lubrication comparable to those used on automobile engines permit the generator to operate for extended periods without maintenance and will shut the engine down if it detects low oil pressure.
This line of generators is set to run on natural gas at the factory, but is field selectable for either LP gas or natural gas. The Vanguard engine has an electronic governor to keep engine speed at a consistent 3600 RPM and the generator output frequency at 60 hertz for the same quality of power as supplied by your electric utility.
The 150 amp Briggs & Stratton automatic transfer switch is a service entrance rated switch with disconnect that installs before the main distribution panel. The transfer switch is controlled by the generator's controller. During normal operation, the switch selects utility power. When a power outage occurs, it connects the distribution panel to generator power.
The air conditioner control module (ACCM) stores the starting power required by central air conditioning units. During an outage, it allows the air conditioners to start when there is enough power available from the generator, preventing overload conditions.
The control panel has a digital display for programming the date, time and the exercise cycle and for viewing the event log.
Operation control buttons select between AUTO and OFF modes. AUTO allows the generator to start, run and shut off automatically. In AUTO mode, the MANUAL button allows the operator to start the generator and run it, and shut the generator off again, which returns the mode to AUTO.
A 15 amp automotive type fuse on the Control Panel protects the internal circuitry. Removal of the fuse will prevent the generator from starting during maintenance or when inspecting the generator.
The 16 kilowatt standby generator has a rust-resistant, steel enclosure that stands up even in tough, coastal climates for long lasting protection against rust and deterioration. This unit is 48 inches wide, 34 inches deep, and 31 inches high. The steel base, suitable for either a gravel bed or concrete pad installation, meets National Fire Protection Association codes and standards better than similar polypropylene bases. This Briggs & Stratton standby generator produces noise at about 69dB, comparable to most residential air-conditioning units.
- 150 Amp Automatic Transfer Switch, Fully Automatic with Service Entrance Disconnect
- Patented A/C Power Control Module to power up to two load dependent, air conditioners
- Installation Base
- Battery Charger
- Hour Meter
1 This generator is rated in accordance with UL (Underwriters Laboratories) 2200 (stationary engine generator assemblies) and CSA (CanadianStandards Associations) C22.2 No. 10004(motors and generators).
2 Warranty details available at briggsandstratton.com.
3 Fuel consumption rates are estimated based on normal operating conditions. Generator operation may be greatly affected by elevation and the cycling operation of multiple electrical appliances – fuel low rates may vary depending on these factors.
4 Review local codes to determine if a transfer switch with separate service disconnect is required.
Not for sale to California
|Manufacturer||Briggs & Stratton|
|Rated Watts||16 LP/14.4 NG|
|Rated Amps||66.8 LP/60 NG|
|Voltage||120/240V Single Phase|
|Decibel Rating||69 dBA||Features|
|Low Oil Alert||Yes|
|Battery Requirement||Group 26, 12V, 540CCA|
|Product Weight||484 lbs.|
|Shipping Weight||602 lbs.|
|Dimensions (Inches)||48L x 34W x 31H (BASE 50.5 x 32.9)||Engine|
|Engine Brand||Vanguard V-Twin|
|Engine Size||993 cc|
|Cooling System||Air Cooled||Alternator|
|Alternator Type||Brushed, Computer Friendly|
|Auto Voltage Regulation||Yes||Fuel|
|NG Power Capacity||14.4kW|
|LP Power Capacity||16kW|
|NG Consumption @ Full Load||224 cu.ft/hr|
|NG Consumption @ 1/2 Load||163 cu.ft/hr|
|LP Consumption @ Full Load||3.14 gal/hr|
|LP Consumption @ 1/2 Load||1.97 gal/hr||Transfer Switch|
|Transfer Switch Model||71069|
|Transfer Switch Amps||150 Amps|
|Transfer Switch Circuits||Whole Panel Service Entrance Disconnect|
|ATS Poles||2 Pole||Warranty Information|
|Consumer Warranty||4 Year Limited Parts and Labor|
All generators include 24 hour delivery notification and residential delivery. Liftgate service is available on all air-cooled generators and some liquid cooled units – Please call for verification. Free Shipping is curbside service only. Curbside service means the freight company will deliver to your address and lower your generator to the ground. The freight company will not back down driveways, place a generator in a building or where it is being installed. You are responsible for arranging the movement and setting of the generator.
Some restrictions apply to "Free Shipping" you may either view our
Shipping Information page or contact us for details.